Second hand

- Malt Crusher

- Whirpool

- Mashing tub

- Wort copper

- Bottlewashing machine

- Tunnel Pasteurizer

- Crates washer

- Filler Labeler

- Keg-lines

Crate washer without turning device

Crate washer is designed for removing impurities and washing of non-deformed plastic crates.

Crate washer without turning device


The washer is an alongside tunnel equipped with a system of nozzles. The crates, carried along by a chain transporter are washed by means of pressure washing solution when passing through.

- This is a tunnel washer with continuous conveyor.
- The cabinet is welded from stainless steel sheets, grade 17.
- Tunnel, water distributor, sieve and suction basket are manufactured of stainless steel grade 17. Alongside the tunnel are removable coverings. Sealing of coverings is ensured by means of labyrinths.
- The washer is devided to washing and spraying part.
- Temperature regulation in the washing tank is carried out by means of regulation valve "Metrik" and the temperature regulator.
- Spraying is performed by a system of spraying tubes.
- Transporting chains are made of stainless steel.
- Drive of conveyor is secured by variator.
- Lower tunnel part forms a collecting vessel of washing solution.
- Circulation of washing solution is secured by centrifugal pump.
- Filtration of washing solution is carried out by a oblique sieve under the conveyor on the one hand and by the suction basket in front of the suction basket on the other.
- Rinsing iperformed by tap water.
- From the collecting tank of rinsing water is completed the level in washing tank.
- Control of washer is concentrated in control panel, placed in the washer.


- The crates are carried along by the trasnporter to the washing tunnel, where in the first phase the spraying of crates with washing solution 60 o warm take place.
- By means of sieves and sucking basket is the washing liquid pumped by largely dimensioned centrifugal pump to spraying tubes. The spraying pressure is about 0.3 MPa /3 atm/ and great quantity of pumped washing liquid/about 20 m3/h / ensures thorough washing even in the case that the dirt adheres especially firmly. - Also the electro-static forces of plastics are strongly affected. This intensive spraying is carried out by ten interconnecting spraying tubes, each of them has 5 nozzles with flat spray and which spray the washing liquid under pressure 3 atm. - Arrangement of spraying nozzles with different spraying angles ensures thorough cleaning of crates from all sides. Used liquid, which can be due to the grade of crate pollution only hot water or hot water with caustic, flows away to the collectiong vessel, which is placed beneath the spraying system.
- The heating of washing liquid is performed by steam – direct spray. The temperature of washing liquid is automatically controlled by thermostat.
- After going through the washing section follows the rinsing section, where the crates are rinsed with clean tap water. This water from final spraying is collected in a special vessel and serves as continuous addition of washing solution.
- After rinsing follows short dripping and the crates are carried along outside the washer. - The discharge conveyor is not a part of the washer, but it can be ordered.
- In order to secure a touble-free operation because of sedimentation of the nozzles of spraying system by water stone, the water hardness should not exceed 10 German degrees.

10. 9. 2013


Are you looking for complete service for your brewery?

• Technical and technological audit
• Development research and step-by-step reconstruction according to customer’s requirements
• Technological projects, individual design of machines and equipment
• Manufacturing, installation, on-site training and after-sale service

» more
Are you looking for complete service for your brewery?

Brno - Starobrno

Czech Republic

» more
Brno - Starobrno